• Quick installation (only 3 minutes) - No need to cut open pipes

• Hydraulic measuring connector serv-Clip® Type 1 No shutdown of installations for mounting on pressurized pipesinstallation of pressure switch, gauge and sensors, particle counters

• Hydraulic measuring connector serv-Clip® Type 2 Short shutdown of installations for mounting on NON-pressurized add. to type 1- installation of flow rate, leakage, temperature and aqua sensors

• Working pressure up to 630 bar (9100 psi)

• Included screwed coupling M 16 X 2 and Viton O-ring (200°)

• Particle measurement according to ISO or NAS classes

Test Hydraulic measuring connectors serv-Clip® with our SENSOR proposal:

• pressure  fluid-Check®

• temperature fluid-Check®

• flow rate / leakage detection fluid-Check®

• aqua fluid-Check® new 2011

and more... measure immediately, in conjunction with virtually every type of measurement coupling and measuring equipment!

For pipe diameters with DIN / SAE international norms: 

• Metric system 10-42 mm

• TUBE - Inches 3/8 - 2

• PIPE  - R-Inches ¼" - 3"

• over 3" (88,9 mm) with adaptor SC-XE-607

•  

Hydraulic measuring connectors serv-Clip® is a patented product and registered trade mark of BOLENDER-Germany.

serv-Clip - the multi-measuring connection in 3 minutes installation..
The use of the hydraulic measuring connectors serv-Clip does away with installation on more than 80% of all normal measuring points. 

Hydraulic measuring connectors serv-Clip on new system
You have only to make plants to install normal measuring connectors at the necessary measuring points. Hydraulic measuring connectors serv-Clip is installed wherever required. If required, you can perform measurements immediately at any point on the system.

Hydraulic measuring connectors serv-Clip on older systems
It is possible to retrofit hydraulic measuring connectorserv-Clip directly at the necessary points of the system. By means of hydraulic measuring connectors serv-Clip you are able to carry out measurements at any point on the system.